| |
 |
 The Rose Rod Turning Machine is powered by a 5.5 HP Honda petrol engine, which is equipped with an oil alert, and On/Off switch. Power is transmitted to the Snow-Nabstedt reduction/reversing transmission via Vee belts and from the transmission to the torque limited rod drive shaft via a chain drive. The torque on the rod shaft is limited to 3.5kgfm and the rod turning speed is limited to 120rpm.
Our MKII machine incorporates a number of safety features, which other machines of similar appearance do not have.
Safety Features:-
LOW ROD TURNING SPEED
Top speed at maximum engine revs 120rpm, as turning rods at high speeds is both dangerous and damaging to rods.
TORQUE LIMITED ROD DRIVE
Rod drive shaft is fitted with a torque limiter set at 3.5kgfm. Some machines depend on the hot shift transmission oil temperature and is difficult to set.
FOUR WHEEL MOUNTING
Gives the machine stability while maintaining ease of use.
HANDLE MOUNTED CONTROLS
Gives operator better control with out bending, therefore the operator is always balanced .
The above features make the Rose Rod Turning Machine eaiser and safer to use for your operator. The Rose Rod Turning Machine is capable of cleaning pipes from 75mm to 450mm in diameter to a distance up to 150m. |
|
Best Suited for pipes up to 150mm dia. Weighing only 15kg with 25m of rods and 8 tools the No.5 Pumbers set is ideal for cleaning sewers up to 150mm. The 1.8 x 6mm sectional steel rods are stored on a 1.1m frame for easy one man transportation |
|
Premium grade spring steel with flex style couplings. 1m, 1.5m & 3m x 8mm (5/16) available |
|
Premium grade spring steel with rigid style couplings. 1m, 1.5m & 3m x 8mm (5/16) available |
|
| |
|
For easy assembly of rod. Pin locks in flex style coupling hole. Also used for light turning |
|
For the assemberly of the flex style rod couplings |
|
Useful tool for removing sand, grease & stringy roots. Cutting edge both sides.
75 to 250mm pipe size. |
|
Used to retrieve a string of sectional rods lost in a line |
|
Goes through flex style coupling hole. Also used for light turning |
|
Placed in the bottom of manholes to guide rods into pipes. Assists in the pushing of rods. |
|
1 man & 2 man ratchet turning handles |
|
Lever action grips on to round rod |
|
Quickly locates lost junctions or missing manholes |
|
Used for fast rod travel and as a puncturing tool |
|
Allows operator to push, turn or pull. Coupling is locked with a pin |
|
For disconnecting rigid style couplings |
|
For cutting roots. Teeth both sides. Must be rotated by power equipment, 75 to 300mm pipe size |
|
Used to punture holes and break up hard deposits, 50 and 100mm blade size |
|
| |
|
For quick removal of rods from a line |
|
Recommended in pullback cutting operations. 100 to 450mm pipe size |
|
For pulling cable through line |
|
For breaking through hard sand |
|
Commonly used to remove rags, cans, sticks & and other obstructions.
75 to 125mm pipe size |
|
Used to create an opening in blocked lines. 40 to 100mm pipe size |
|
General purpose tool for roots and hard deposits.
Has cutting edge on back so it will cut when pulled in 75 to 300mm pipe size. |
|
For storage and easy removal of rods |
|
